P a g e |
32
After making any changes, you are redirected to the
Device Management
screen. From the
Restart Module
frame,
click
Restart
to reboot the system.
Close down your web browser to end the process. You may need to reconnect your PC to the VS+ to continue
using the system.
Be aware that, although interference from other Wi-Fi networks is a possibility, RF (radio frequency) interference
can be generated by almost any device that emits an electromagnetic signal – from microwave ovens to Bluetooth®
headsets. Such interference can be highly variable and intermittent. The closer the source of interference to the
VS+ or the PC, the greater the level of interference. It may be the case that the only way of overcoming this problem
is to identify and remove the source of the interference.
6.2 IP address
By default, the IP address of the VS+ is 10.10.100.254. It is strongly recommended that this address is left
unchanged.
However, there may very occasionally be a specific need to change the IP address, for example in order to avoid
clashing with an adjacent network or perhaps to fit into a pre-existing, on-site network.
In this case, please contact Carlson for advice on carrying out this modification and on the procedure for
reconnecting with
Carlson Scan
using a non-standard IP address.
Note: In the event that you do change the IP address, it is your responsibility to maintain a record of any changed
network settings. If you fail to do this, you may find it impossible to reconnect to the VS+. You must also inform
Carlson of any IP address change when service or support is required.
