Carlson Void Scanner, Руководство пользователя

Страница: 11 / 35

P a g e | 11
•
Green flashing light: charging is in progress.
•
Solid green light: charging is complete.
•
Red flashing light: there is a fault with the battery charger. Contact your local Carlson service centre for
advice.
•
No light: there is no power to the battery charger or no connection with the battery.
A fully discharged battery requires around three hours to completely recharge from the mains supply.
WARNING: Only use the supplied battery charger to charge the internal or the external battery.
The battery charger is not intended for outdoor use.
3.3 Power/data cable
The basic Void Scanner system is supplied with a 13.6 m power/data cable to connect the Void Scanner probe to
the interface box, and from there to the power source and the PC.
This 13.6 m power/data cable can also be used to connect the Void Scanner probe to the Wi-Fi box, bypassing the
interface box, extra cables and external power source.
Alternatively, a shorter, 1.5 m power/data cable is supplied with the Void Scanner Wi-Fi box. This shorter cable can
take the place of the 13.6 m power/data cable where the Void Scanner Wi-Fi box and probe are mounted close
together: for example, if the probe is on a remotely operated vehicle or on the end of a boom.
When the battery pack is used to operate the Void Scanner, the interface box is not required.
The 6-pin ‘L’-shaped connector attaches to the Void Scanner probe. The 4-pin connector attaches to the ‘Probe In’
connector on the side panel of the Void Scanner Wi-Fi box.
Figure 6 The shorter, 1.5 m power/data cable