This document contains confidential and proprietary information that remains the property of Carlson Software Inc.
Page 1 of 5
Updated 6/18/2015
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
102 West 2
nd
Street
Maysville, KY 41056
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
Phone: (606) 564-5028
Fax: (606) 564-6422
Carlson BRx5 GNSS Receiver Base/Rover Quick Start Guide
Internal UHF Radio Configuration
This Quick Start Guide outlines the steps to follow using SurvCE/SurvPC 4.05 or higher to setup and
configure the BRx5 GNSS receiver as a base and rover using the internal UHF radios for communication.
Install the Batteries
Before configuring the BRx5, you will need to install the two batteries in each unit. To install a battery:
1.
Remove the battery tray by squeezing the
thumb lever down and with your fingers
placed under the lip on the bottom of the
battery tray, pull the battery tray Straight out
from Brx5. Some users find it easier to turn
the BRx5 upside down and use their fingers to
pull the battery tray release lever up while
hooking the thumb on the battery tray lip and
pulling out.
2.
If there was already a battery installed, remove it
from the tray.
3.
Insert the new (charged) battery into the battery tray
making sure the end of the battery with the leads (on top) points
away from the tray as shown below.
4.
Replace the tray, making sure the tray snaps into place. Repeat this
process for the other battery tray.
Powering the BRx5 On and Off
Power On
: Press and hold the
Power
button until the S320 powers up (until you hear one beep).
Power Off
: Press and hold the
Power
button for 3 seconds (until you hear three beeps or see the
External Power Status LED (#4) flash).
Note:
When you power on the BRx5 the LEDs go through a ‘heartbeat’ sequence; during this time the
modules power up and the devices initialize.
