How to install a Sx2WEB system
38
2
Installing the smart-house system
The installer has to perform the following steps to install a smart-house system:
1. Define the required smart-house functions and the relevant smart-house modules
2.
Define the number of necessary bus generators, following the suggestion described in
paragraph
How to define the number of Dupline® networks
3.
Size the 24 Vdc power supply as described in paragraph
Sizing of Carlo Gavazzi DC power
supply
4. Install the Dupline® bus, following the suggestion given in paragraph
The Dupline® bus
5. Position and design the cabinet(s) correctly, following the suggestion given in the description of
the Dupline® bus and the HSbus.
6. If the modem is part of the installation, it has to be placed to the left of the SX2WEB24
7. The DIN-rail module has to be placed as described in the Dupline® a HSbus paragraphs
8. Connect the loads and inputs/outputs as described in the relevant datasheets of the DIN-rail
modules (ON/OFF light, d
immable light, blind motors, …)
9. If present, connect the energy meters to the serial port COM 2 and configure them (modbus
address, baud rate,…)
10. Connect the LAN if present via the Ethernet connector
11. Connect the power supply: 24Vdc and 230Vac
When switching on the Sx2WEB24
, the following LEDs will light up on the front panel: green “ON” LED
(indicating the device is powered), yellow “BUS” LED (indicating HSbus activity), yellow COM2 LED
(indicating COM door activity), blue “USB” LED (indicating the presence of a USB device) and red
Status LED (at the first start-up it will be ON, indicating that no configuration is present or when it is
connected to a PC via the Sx tool). When connecting the network cable, the Ethernet port LEDS will
also light up.
When switching on the SH2MCG24, the following LEDs will light up on the front panel: green “ON” LED
(indicating the device is powered), yellow “BUS” LED (indicating HSbus activity), yellow Dupline® LED
(indicating Dupline® bus activity).
When switching on the SH2UMMF124, the following LEDs will light up on the front panel:
-
Green LED:
ON (indicating the machine is powered)
-
Blue LED:
f
ast blinking
: searching for the cover signal / not registered / switching off.
slow blinking
: service is registered and signal is available.
steadily on
: communication under way.
When switching on the SH2DSP24, the green LED will be lit up, indicating the module is powered.
See the LED/LEDs on the dongle USB modem for any network information.
When switching ON the other DIN-rail I/O modules, the following LEDs will light up on the front panel:
green “ON” LED (indicating the device is powered), yellow “ON” Dupline® LED (indicating Dupline® bus
activity), red I/O LEDs (indicating the relevant input/output status).
After connecting and powering the Sx2WEB24, connect it to the Sx tool, following the instructions in the
Sx tool manual.
The Sx2WEB24 IP settings are factory-configured to start as DHCP. If no routers are present, please
change the IP address as described in the Sx tool manual, by using the USB key.
To create a configuration, please follow the instructions in the Sx tool manual.
