Carl Valentin DPM IV 107, Краткое руководство пользователя

Страница: 63 / 150

DPM IV
English 63
Print Control
As the direct print module is always in control mode, print orders can only be transmitted but not started via the existing
interfaces (serial, USB or Ethernet).
The print is started by a start signal to the ‘print start-control input’. So that the control unit
detects when the start signal can be set, it is possible and mostly necessary to track the print status via the control outputs.
Initial Operation

AFter all connections are completed, switch on the control unit.

Insert the transfer ribbon (see description below).
Load Transfer Ribbon
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be cleaned using printhead and roller cleaner
(97.20.002).
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure good
ventilation.
A
B
D
C
•
Open the cover of print mechanics.
CAUTION!
Risk of scraping when inserting the transfer
ribbon res. when removing the used transfer
ribbon!

Be careful with the bearing plate edges!
•
Load a new transfer ribbon roll (A) onto the unwinding unit (B)
and push it until it stops.
NOTICE!
Please observe that the color of the transfer ribbon is
on the outside.
•
Load an empty rewinding roll (D) onto the rewinding unit (C)
until it stops.
•
Load the transfer ribbon according to illustration
•
Stick the transfer ribbon with an adhesive tape to the empty
roll and tighten the transfer ribbon with some turns of the roll.
•
Close the cover of print mechanics.
CAUTION!
Risk of crushing and damage to objects when
closing the dust cover!

When closing the dust cover, ensure that
neither parts of the body nor objects (e.g.
clothes, jewelery) are clamped!
NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be damaged,
the transfer ribbon should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.
CAUTION!
Impact of static material on people!

Use antistatic transfer ribbon, because static discharge can occur when removing.