Carl Goldberg Products decathlon arf, Руководство пользователя

Страница: 8 / 29

WING STRUT INSTALLATION
1.
!
Collect the following parts:
(2) Wing strut
(1) Wing/fuse assembly
(4) Small control horn
(8) #2 x 1/2” Pan head screw
(4) Metal clevis
(2) Nylon straps 7/8” long
(2) #4 x 1/2” Pan head screw
2.
!
Place the 7/8” long nylon strap into the notch
behind the landing gear cut out.
!
Mark the hole location and drill a hole using a
3/32” drill bit.
3.
!
Mount the strap onto the fuselage using a
#4 x 1/2” pan head screw.
!
Repeat for the other side of the fuselage.
4.
!
Place the wing strut onto the nylon strap.
NOTE: The short front of the strut should be parallel
with the front of the wing. In the above photo
the short side is in front.
5.
!
Modify the small control horns by cutting, as
shown above.
6.
!
Thread the metal clevis onto the threaded
wires at the outer end of the strut until the
wire protrudes into the center of the clevis.
!
Install the modified control horns onto the
clevis at the end of the strut.
!
Mark the modified control horn hole locations
onto the wing.
NOTE: Keep the front strut parallel to the leading
edge of the wing.
7.
!
Drill the control horn holes, using a 1/16”
drill.
!
Screw the modified control horns to the wing,
using #2 x 1/2” pan head screws.
!
Repeat these steps for the other strut.
8.
!
Remove both struts when completed.
8