Carl Goldberg Products decathlon arf, Руководство пользователя

Страница: 7 / 29

2.
!
Using epoxy, mount the 5/16 x 1-3/4” dowels
into the holes in the notch of the leading edge
of the wing. Make sure to leave about 1/2” of
dowel sticking out of the front of the wing. You
may wish to slightly taper the exposed dowel
ends for ease of insertion into the fuse holes.
NOTE: If the covering on your wing has loosened in
transit, refer to the covering section of the
"INTRODUCTION" before continuing.
1.
!
Collect the following items:
(1) Right wing
(1) Left wing
(2) 5/16 x 1-1/2" dowel
(1) 7/8” x 21-3/4” aluminum tube
MOUNTING WING TO FUSELAGE
3.
!
Insert a 8-32 blind nut into each hole in the
wing mounting block, with the teeth pointing
upward into the blocks.
!
Temporarily insert a 8-32 x 1" screw with a
washer into each hole on the other side of
the mounting block and draw the blind nut
teeth up into the wood.
!
When the blind nuts are firmly seated in the
wing mount blocks, remove the screws.
4.
!
Gently prodding the covering, locate the hole
next to the center of the of the wing, close to
the trailing edge.
!
Carefully remove the covering OVER THE
HOLE in the wing on both the top and the
bottom.
!
Next, locate the holes in the wing bolt plate
and again, carefully remove the covering
over the holes.
!
Do the same to the other wing panel .
5.
!
Insert the aluminum tube into one wing half
and push the tube into the wing until it stops.
Then insert the other wing half onto the tube
and slide the wing halves together.
!
Tilt the leading edge of the wing down into
the fuselage and insert both dowels in the
holes that are in the front of the fuselage
!
Insert a 8-32 screw with a washer into each
hole in the wing bolt pad and then insert each
screw into the holes near the trailing edge of
the wing.
!
Tighten both screws down until they are tight.
5.
!
Repeat these steps for the other half of the
wing, so that both servo extensions are exit-
ing the holes near the center of the wing.
7
!
Tape the extension securely to the wing, so
that it will not slide back in while you are
working. Screw the servo door onto the wing.