___________________________________________________________________________
_____________________________________________
By Carepeutic®
11
in red, the two-digit LED display immediately shows the
current water temperature.
•
Press the ON/OFF button again to turn off power
completely.
•
The default massage program is P1 once the power is turned
on.
•
The default massage time is 50 minutes once the power is
turned on. (Figure 1, shows 50 min on the LCD display).
•
The default minimum water heating temperature is 35°C and
maximum water temperature is 40°C once the power is
turned on.
5 Heating
•
Press the
Heating
button to turn on/off heating function.
Automatic water temperature balancing system:
•
The default maximum water heating temperature is 40°C
once the power is turned on.
•
If the just-filled-in water temperature is lower than 40°C, the
Heating
function will be turned on automatically and
stopped when its water temperature reaches 40°C. When its
water temperature cools down below 40°C, the Heating
function will be turned on automatically again, and so on.
•
When the water temperature reaches its default maximum
temperature (40°C), the
Keep Warm
indicator light on LCD
display will be on (Figure 1).
Note: the
Heating
function will not be on if your fill-in water
temperature is already higher than its default maximum 40°C.
Changing the Default Water Heating Temperature:
•
If you prefer to change its default water temperature to be
higher or lower than 40°C, you can press the TEMP + /
TEMP - to reset the maximum water heating temperature.
•
The highest heating temperature you can set is 48°C.
•
The lowest heating temperature you can set is 35°C.
6
Temp+/-
When to use Temp+/- :
•
The
Temp+/-
button can be used to change maximum water
heating temperature under any massage modes.
•
Press
TEMP +
to increase water heating temperature you
want. After 3 seconds, its LCD display will switch back
showing its current water temperature.
•
Press
TEMP -
to decrease water heating temperature. After
3 seconds, its LCD display will switch back showing its
current water temperature.
