___________________________________________________________________________
_____________________________________________
By Carepeutic®
10
1
Put the Device
together
•
Refer to Figure 2/3/4.
•
Remove the tape on the waterfall cover (Figure 4).
•
Put back the power cord storage cover to the massager. And
close the storage compartment with power cord inside so
that it will not get wet when filing in water (Figure 2).
•
Pull up the waterfall cover to change or replace the herbal
bag basket (optional) (Figure 3).
•
Check and make sure there is no any damage on the product
such as its case and power cord.
2 Stabilize
the
Device
•
Allocate the massager on the flat floor where you want to
use.
•
Make sure the 4 wheels on bottom of massager are stabilized
so that the massager will not move away during use.
•
Do Not plug in power cord to wall outlet now.
3 Filling
in
Water
•
You must fill in water before turning on the foot bath
massager. Never try to operate this device without having
water inside the water container.
•
Filling in water with water bucket. Do NOT put your
massager under faucet directly.
•
Be careful NOT to spill water onto the cover or control
panel.
•
To save electricity or speed up water heating, you can put in
warm water but the warm water temperature should be less
than 40
℃
Celsius degrees.
Water Level: (refer to Figure 4)
•
Water level should not higher than the waterfall output level
if you are using waterfall function.
•
Water level should not higher than the water jet output level
if you are using water jet function.
•
The maximum water level is right under the waterfall output
spot.
•
If you are using both waterfall and water jet function, water
level should not higher than water jet output spot.
•
Never filling in water that is higher than its maximum water
level, it'll affect the waterfall or water jet massage function.
•
After filling in water, make sure your hands are not wet, use
a dry cloth to clean up any water drops on control panel.
•
Plug in power cord to wall outlet.
4 ON/OFF
•
Press ON/OFF button once, “ON/OFF” indicator light is on
