Carel compactSteam CH002V1000, Руководство пользователя

Страница: 18 / 28

compactSteam
Cod. +030221905 – rel 1.0 - 18 Jannuary 2006 18
4.3 Starting compactSteam
•
Insure that the external power is turned on. The yellow Power LED will be lit.
•
Push the top part of the On/Off button so that the I part is in. The compactSteam is now ready to operate.
•
When there is a call for humidity, compactSteam will close its power relays and send power to the electrodes in the plastic steam generator. The green
Operation LED will light, indicating that operation has begun.
4.4 Starting with a new cylinder
When starting with a new cylinder, you should activate the cylinder cleaning function as follows:
1.
Switch compactSteam off.
2. Keep pressed both buttons, “ reset/sel ” and “ drain ”, and switch compactSteam back on until the display shows 00 and the spanner blinks; then release
the two buttons.
3. Keep pressed “ reset/sel ” until the display shows 04.
WARNING : do NOT confirm any value higher than 04. In case, press “ reset/sel ” until the display goes back to the normal operating mode and restart from step
1.
4. Press “ drain ” (min. 1 second): the cleaning starts.
During the cleaning, the electrodes are powered and water is filled in until it touches the high-level sensor OR the phase current equals 20 A, whichever occurs first.
After either of the events is detected, the boiler is fully discharged with the electrodes un-powered (the drain valve and the drain tempering valve are activated for 3
minutes). Warming the filling water helps washing out any mould release or dirt.
When starting the unit with a new or empty cylinder, it may take a significant amount of time (hours) for the unit to build up enough mineral concentration to reach
rated capacity. This time can be shortened by the addition of Alka-Seltzer or salt (teaspoon) through the steam outlet on top of the cylinder.