S
LIDEOUT
C
OVER
Service
Manual
Carefree of Colorado
2
052559-301r2
C
ANOPY
R
EPLACEMENT
Figure 1. Replacing the Fabric.
R
EMOVING THE
F
ABRIC AND
R
OLLER
T
UBE
1. Close the room if open.
CAUTION
The springs are wound and under tension. The spring locking pins must be
inserted before continuing otherwise the roller tube can spin out of control and cause personal
injury and/or property damage.
2.
(Detail B)
On the right end of the roller tube, insert a spring locking pin through the roller bearing and
spindle; it may be necessary to twist the roller to align the holes. The locking pin is a 3/16 x 1 1/4 cotter
pin or equivalent. Place tape over the head of the pin to avoid the pin coming out.
3. Remove the two fabric retaining screws from the awning rail.
4.
(Detail A)
Remove the 10-32 screws from the endcaps (one in each endcap)
5. On the right side, remove the two #10 x 1/2 screws from the mounting bracket.
6. Hold the roller tube and slide the right endcap assembly out and away from the roller tube. It is not
necessary to remove the endcap assembly from the bracket.
7. Pull the roller tube from the left endcap then slide the fabric and roller tube out of the awning rail.
8.
(Detail C)
Remove the retaining screws from the roller tube spindles and save. Remove the fabric from the
roller tube.
I
NSTALLING THE
F
ABRIC AND
R
OLLER
T
UBE
If replacing or repairing the roller tube, make the necessary repairs before continuing.
1. Unfold the replacement fabric.
2.
(Detail C)
Slide the black polycord of the fabric into the fabric slot of the roller tube. Orient the fabric with the
hem on the bottom (the hem will then roll against the roller tube). Center the fabric in the roller tube.
Lock Pin
#10 x 1/2 Screw
(2 per bracket)
10-32 x 1/2 Screw
(1 for each endcap)
DETAIL
A
DETAIL
B
CS011
#6 x 3/8 Screw (2 plcs)
Right End Cap
Slide Fabric in Rail
6” Approx.
DETAIL
C
Hem
on Bottom
#10 x 2 Fabric
Retaining Screw
Pull Down and Hold Polycord
While Placing Retaining Screw
Guide
