Carefree Mirage 2-Stage, Руководство по обслуживанию

Страница: 19 / 34

Carefree of Colorado Service Manual M
IRAGE
2-S
TAGE
052588-301r4 15
D
IAGNOSTIC
T
ESTS
– D
IRECT
R
ESPONSE FOR
M
ULTIPLE
A
WNINGS
Refer to the Wiring Diagrams in the next section for wire and cable connections.
T
ESTING THE
S
YSTEM
– M
ULTIPLE
A
WNINGS
All function buttons are press ON. The auto-functions continue until the awning is fully extended or
retracted. Pressing the button a second time will stop the function. It is not necessary to hold the button
while the function is active.
1. While observing the control panel, have a second person initiate 110VAC power to the coach and
awning system. The following should occur:
1.1 The Power ON/OFF and Wind Speed LEDs will briefly illuminate.
1.2 The system then goes to the default settings: The P
OWER
“ON”, A
UTO
-R
ETRACT
“ON” and M
EDIUM
Wind Speed LED will be on.
NOTE: If the awnings operate from the touch pad but no LEDs are illuminated, check that the
jumper cable between the controllers is plugged into AUX (motor #1) and ACC (motor #2).
2. Press the P
OWER
“OFF”. A
LL
LEDs should be extinguished. The P
OWER
ON/OFF button disables all
functions including Auto-Retract and the optional RF remote. It does not disconnect the 110VAC power.
3. Check the extend function.
3.1 Press the P
OWER
“ON.
3.2 Press the Awning #1 E
XTEND
button. The awning should extend.
3.3 Press the extend button again. The awning should stop
3.4 Press the extend button a third time. Observe the awning, it should fully extend. The system performs
an auto-tension action when the awning is fully extended. The awning rolls in reverse to tension the
fabric. The auto-tension feature works only with the extend function when the awning is fully extended.
4. Check the retract function.
4.1 Press the Awning #1 R
ETRACT
button. The awning should retract.
4.2 Press the retract button again. The awning should stop
4.3 Press the retract button a third time. Observe the awning; it should fully retract to the closed position.
NOTE: If the awning moves in the opposite direction than the label, the red and black
MOTOR
wires
are reversed in the control box.
5. Repeat steps 3 and 4 for each of the Extend/Retract button combinations.
NOTE: The Extend All and Retract All buttons should extend/retract all awnings.
6. Test the Auto-Retract function:
6.1 Fully extend awning #1.
6.2 Set the W
IND
S
PEED
to the lowest setting.
6.3 Create a firm but gentle vertical rocking motion with the leading edge of the awning. The awning should
retract after 2-3 seconds of the motion.
7. Repeat step 6 for each of the awnings.
8. If the optional Ignition Sensor is installed :
8.1 Partially retract the awning.
8.2 Turn the vehicle ignition key ON.
8.3 Press the E
XTEND
button. The awning(s) should not extend.