Carefree of Colorado SUNDIAL PATIO AWNING, Инструкция по установке и эксплуатации

Страница: 8 / 20

C
AREFREE OF
C
OLORADO
S
UNDIAL
P
ATIO
A
WNING W
/ M
ANUAL
O
VERRIDE
6 052537-001r5
S
ECURING THE
A
WNING
NOTE: This procedure requires opening the awning. For manual awnings, use the manual crank.
For motorized awnings, follow the Manual Override instructions on page 14. For motorized
awnings, these steps can be done after the electrical installation when motorized power is
available.
Drill in
this area
O 3/16” Thru
Ream case only to O 5/16”
1/4 x 1 1/2 Lag Screw (3 plcs)
MIRAGE010
Figure 8. Securing the Awning.
1. Adjust the awning horizontally as required.
2. Open the awning approximately 3 feet to access the back panel of the awning case.
3. Drill three (3) 3/16” holes through the case, mounting plate and into wall (do not go through interior
surfaces of wall) in the approximate areas shown in Figure 8.
4. Ream out the holes in the case only to 5/16”.
5. Attach the awning case to the mounting plate and wall using three (3) 1/4 x 1 1/2 lag screws.
NOTE: For installations using the optional roof top brackets, the screws will project out the back of
the awning mounting plate.
6. From inside, seal the wires and access hole with a quality silicone sealant.
This completes the basic awning installation. For manual configurations, no further action is required. For
motorized configurations, proceed to the next section "Electrical".
Table of Contents