UI SmartSeatPro
II
User Guide. Iss1 06/22
13
5. Armrest Height Adjustment & Removal
To adjust the armrest height, locate the two
plunger pins on the inside of the armrest;
one towards the front and one towards the
rear.
1. With a plunger pin in each hand, pull
both outwards to disengage.
2. Slide the arm up or down to adjust to
the desired height.
3. Release the plunger pins to lock into
position, and you should hear an
audible click.
4. Armrest height can be set differently
from front to back, resulting in angled
armrests, which may be indicated
for users with specific upper limb
positioning requirements.
5. The armrest height should be based on
the outcome of the user’s assessment;
please refer to these measurements or
seek further guidance from the Health
and Social Care Professional.
The armrests (A) can be removed to aid
user transfers, positioning, cleaning and
servicing:
1. Locate the two quick release levers;
one is located at the front of the seat
base and one at the rear.
2. Pull in an upwards motion to loosen.
3. The armrest can then be removed.
The armrest can be removed
completely for side transfers.
5a. Ratchet Height Adjustment
Armrest Upgrade
CareFlex offers an upgrade to the
armrests, which uses a ratchet mechanism
for simple and regular arm height
adjustments between 200mm to 270mm
from the seat cushion.
•
With the armrest attached to the
chair, lift it upwards; as it raises, you
will hear audible clicks which move
in 13mm increments. The armrest
height will be set in position after each
audible click.
•
To lower the armrest, raise it entirely
to the top of its travel; you will then be
able to lower the armrest back to its
lowest setting.
Plunger pins located on the inside of
the armrest.
Ratchet mechanism upgrade for
armrest height.
A
