20
■
Cleaning the battery
If the battery is contaminated by water, battery acid, dust or other substances, it will
discharge quickly. The battery supplied with the CareCo scooter is sealed and is maintenance
free with no risk of battery leakage. Please follow the steps below to clean the battery.
1.
Turn the scooter power switch to ‘OFF’.
2.
Remove the seat and dust cover.
3.
Remove the shroud and unplug the terminal of the tail-light and signal lights.
4.
Use a clean cloth to wipe off the soiled area.
5.
Take out the battery.
6.
Clean the battery with a clean cloth. If the terminal is covered by white powder, please
wipe it
clean using warm water.
Warning
1.
The wiring system and charger are assembled in the battery pack during assembly by the
manufacturer. Do not attempt to re-locate the wiring system by yourself. The improper
layout of the wiring system may result in the wires being pinched by the battery box,
which might cause an electronic system failure.
2.
Be sure the battery wires are connected to their correct battery terminal.
Suggestions
If necessary, contact CareCo for advice about maintaining and replacing the battery.
Suggestions
1.
Make sure the terminals are installed properly and put the cover back on.
2.
Do not use the battery to charge telecom equipment or other items.
3.
Battery efficiency will vary with outside conditions; the driving distances will be shorter
in the winter. If the vehicle is not used for a long time, please charge the battery at
least once every week.
