www.careco.co.uk
CareCo, Hubert Road, Brentwood, Essex, CM14 4JE
10
Fitting the cuff
1. Put the cuff on a table flatly with the velcro side down. Pass the end
of the cuff through the metal loop so that a circle is formed. The
velcro fastening will now be facing outwards (ignore this step if the
cuff has already been prepared) .
2. Push the cuff over the left upper arm so that the tube points in the
direction of the lower arm.
3. Wrap the cuff on the arm as illustrated. Make certain that the lower
edge of the cuff lies approximately 2 to 3 cm above the elbow and
the rubber tube leaves the cuff on the inner side of the arm.
4. Tighten the free end of the cuff and close the cuff by affixing the
velcro.
5. The cuff should be snug on your upper arm so that you can fit 2
fingers between the cuff and your upper arm. Any piece of clothing
that restricts the arm must be taken off.
6. Secure the cuff with the velcro closer in such a way that it lies
comfortably and is not too tight. Lay your arm on a table (palm
upwards) so that the cuff is at the same height as the heart. Do not
bend the tube.
Note:
If it is not possible to fit the cuff to your left arm, it can also be placed on
the right. However, all measurements should be made using the same
arm.
Setting mode
Digi Blood Pressure Monitor -
DL08146
Note:
When using the AC adapter, the power of battery won’t be consumed.
If the measurement is stopped suddenly for any reason, the process must be re-started in order to obtain
an accurate reading.
