21
FactorY or commercial aPPlications
The port labelled “Ext” at the rear of the Smart Dialler is not normally used in domestic situations but for
OH&S applications in the workplace where an external strobe/alarm maybe required. CareAlert can provide
the strobe/ alarm which comes with 10 meters of cable to allow for external mounting. When the buttons are
pressed for help not only does the dialler begin dialling for help but the siren and strobe sounds immediately
as well, drawing attention to other employees that help is being sought for in that location.
sPeciFications anD aPProVals
1.
Main Smart Dialler supply: 12V DC plug adapter / 1,000 mA
POWER ADAPTOR The 240-Volt AC Power Adaptor has a built in fusible link that will fuse if more
than 300 volts is recorded. This is to help prevent any damage to your CareAlert Smart Dialler in
the event of a Power Surge. Should this fuse blow you will need to purchase a new Power Adaptor
online.
warrantY Does not coVer Power sUrGe DamaGe.
2.
Base Station battery: 6 Volt rechargeable. You will need a small Phillips head screw driver to
change this battery (screwdriver provided).
3.
Wireless pendant power supply: 3 Volt Button Battery CR2032.
You will need a small Phillips head screw driver (provided) to fit and change this battery.
4.
Wireless pendant operation range up to approximately 150 metres in open space. This distance
can vary either greater or less in certain environments. The operation frequency is 916MHz.
5.
The “CareAlert” Smart Dialler and its components have been fully tested and approved for use in
Australia and New Zealand by a registered NATA accredited laboratory to the necessary standards
applicable.
