Cardinal RD2, Руководство по установке

Страница: 17 / 24

3601-M511-O1 Rev C
•
RD2 Series
13
ERROR AND STATUS DISPLAYS
The RD2 Remote Display is equipped with software that tests various portions of its circuitry
and verifies proper operation. Should a problem be detected, a message will be displayed.
The following lists the messages displayed and their meaning:
Display Meaning
_ _ _ _
Ab
This will be displayed for a maximum of 4 seconds when the display is
configured for Auto-baud detection. Note that while detecting the baud
rate, the intensity of the digits will increase to full brightness.
Erro1
Erro2
Auto-baud feature could not detect baud rate of indicator. Verify baud
rate of indicator serial port is set for 2400 to 38400 baud and try again.
If error continues, manually set baud rate of display and indicator.
autofo
m
This will be displayed for a maximum of 3 seconds when the display is
configured for Auto-format.
Erro3
Auto-format feature was unable to automatically select a serial input
protocol. Verify indicator serial output is one of the eight serial formats
listed in Setup and Configuration and try again. If error continues,
manually set serial format of display and indicator.
Nodata
On some indicators, the serial output will stop when displaying an error
code or if in an "input" mode. When the serial input to the display stops
for any reason, after 3 seconds this message will be displayed.
Correct error condition on the indicator. Cancel or complete the input
operation on indicator.
This message could also indicate the serial connection between the
indicator and the display has been lost.
Check for a broken, loose or disconnected serial cable between the
indicator and the display.