Cardinal Detecto 6880, Руководство по эксплуатации

Страница: 5 / 12

0064-M020-O1 x 6880 & 6880KGEU
Page 3
OPERATING INSTRUCTIONS
WARNING - This product is not intended for use in transporting patients! It
is to be used ONLY for weighing a patient. Failure to observe this warning
may result in serious injury to the patient and/or the scale operator.
1. Install six (6) “AA” size batteries or if ordered with the scale, plug the small connector end
of the power supply cord into the power jack located in the bottom right corner at the back
of the indicator, then plug the power supply module into an appropriate power receptacle.
NOTE! DO NOT connect a power supply to the indicator if Alkaline batteries are installed.
2. Install the indicator on the scale bracket (between the padded handles) and then connect
the load cell cable.
NOTE! For more information on installing the batteries (or the power supply
module), mounting the indicator on the scale bracket and connecting the load
cell cable, refer to the 750 Owner’s Manual, 8555-M260-O1.
3. Place the chair scale on any hard, level, flat surface or low-cut carpet.
4. With no weight on the scale, press the [ ON/OFF ] key. After a second or so the display
should indicate a zero weight with the ZERO annunciator turned on. If the display does not
indicate zero, press the
[ ZERO ] key to zero the weight display.
5. Set the patient on the scale and have them remain motionless for several seconds until the
scale display shows their weight.
6. To re-zero the scale, remove the patient from the scale and press the [ ZERO ] key.
Lift-A-Way
Armrests
Fold Up
Footrest
Indicator
Optional
Power
Supply
Module
IMPORTANT!
Lower footrest after patient is seated.
Raise footrest before patient stands up.
NEVER STAND UPRIGHT ON FOOTREST!