8200-M628-O1 Rev A
212G/212GX Installation & Technical
Page 37
SETUP AND CALIBRATION, Cont
LrP=
(Local/Remote Port – only displayed if
SERSCL
, in the
A-D
section,
was set to YES )
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press
the
ENTER
key again to save it. Otherwise, using the numeric keys enter the new setting and
then press the
ENTER
key to save it. Allowable values are:
1
for port 1 or
3
for the optional
2xx-RS232 card (if installed).
Print
(
Print?
) - Print Tab Settings
With
(
Print?
) displayed, press the
ENTER
key. The display will change to show the
current setting “
nO
”. To skip configuring Print Tab Settings and proceed to the
FSPAn?
menu,
press the
ENTER
key again. To configure Print Tab Settings, press the numeric key
1/YES
and then the
ENTER
key. After pressing the
ENTER
key the display will change to
Port=
.
The general format for the input is A = YY.XX where A is the
character identifying the data printed, YY is the number of lines
down and XX is the number of spaces to the right.
NOTE!
Enter 00 in either location, YY or XX, to disable
the data from printing.
Port=
(Select Port for Printer)
Press the
ENTER
key to show the current value. If the setting displayed is acceptable, press
the
ENTER
key again to save it. Otherwise, use the numeric keys to enter a new setting and
then press the
ENTER
key to save it. Allowable values are: 1 or 2.
NOTE!
Although either port can be used for the printer port, it is recommended to
use the bi-directional port 1 with a bi-directional cable.
HoUr=
(Time Print Location)
Press the
ENTER
key to show the current setting for the location of time printing. If the setting
displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric
keys to enter a new location and then press
ENTER
to save it.
dAtE=
(Date Print Location)
Press the
ENTER
key to show the current setting for the location of date printing. If the setting
displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the numeric
keys to enter a new location and then press
ENTER
to save it.
id =
(ID Prompt Print Location)
Press the
ENTER
key to show the current setting for the location of ID prompt printing. If the
setting displayed is acceptable, press the
ENTER
key again to save it. Otherwise, use the
numeric keys to enter a new location and then press
ENTER
to save it.
CnC n=
(Consecutive Number Print Location)
Press the
ENTER
key to show the current setting for the location of consecutive number
printing. If the setting displayed is acceptable, press the
ENTER
key again to save it.
Otherwise, use the numeric keys to enter a new location and then press
ENTER
to save it.
Содержание 212G
