CARBONEX ECHO-PG, Техническое и эксплуатационное руководство, Страница: 12 / 34

E C H O - P G V E R S I O N E N 1
12
7. Installation
7.1. Unpacking
During unpacking, check completeness of the set according to the proof of delivery.
Check if the power switch on cage device was in OFF position during transport and storage.
The switch in ON position could cause discharging of battery.
7.2. Cage device
Cage device is shown in drawing no.28PG.01.01. Housing is divided into two parts. At
the bottom there are placed electronics board, buttons and switches, at the top socket battery
BAKS. The walls of the housing are made of stainless steel sheet. In the bottom side of the
housing there are sockets for connecting: sensors and couplers. In the right side there is socket
to charge battery BAKS without removing it out of housing. Access to battery and electronics
board is possible after unscrewing proper cover. Device
is designed for mounting on
crosshead by means of 4 screws M8.
7.3. Coupler SK
Coupler SK is shown in drawing no.28PG.03. Coupler consists of two parts, to allow
his assembly around rope. There is a ferromagnetic core with coil inside housing of device.
Core and coil are encapsulated by chemical compound. There is shown in drawings
no.28PG.03.01.
7.4. Manipulator EPG
Manipulator EPG is shown in drawing no.28PG.01.04. It is designed to
communication with headframe device. If you want to use additional signaling device instead
of manipulator to the socket should be connected additional plug kit, otherwise will be
emitted a continuous alarm.
7.5. Headframe device
Headframe device is shown in drawing no.28PG.02.01. Housing consists of three
parts: power supply unit from the left side, main unit in the center and input/output circuits
unit at the right side. Center unit consist of mainboard and subrack for 7 eurocards.
Headframe device is designed for mounting in the winding engine room using 4 screws M8.
Method of connecting headframe unit is shown in drawing no.28PG.02.04.
7.7. Coupler SS
Coupler SS is shown in drawing no.28PG.04. Coupler consists of two parts, to allow
his assembly around rope. There is a ferromagnetic core with coil inside housing of device.
Core and coil are encapsulated by chemical compound. There is shown in drawings
no.28PG.04.01. The couplers SK and SS differ only way of fixing.