Carbolite Gero GPCMA 174, Инструкция по установке и эксплуатации

Страница: 34 / 50

9.0 Commissioning
Note: This equipment should not be put into use until it has been commissioned by a
competent person in accordance with the instructions contained within this manual,
and any local regulations. Carbolite Gero offer an installation and commissioning
service. Please contact Carbolite Gero Service for details.
9.1 Pre-Commissioning
When the product is cold and disconnected from the power
supply, visually check the following: Checked
by:
Siting / Securing
Check that the product is placed on a secure, level
surface and cannot topple over.
Packaging
Check that all packaging material has been
removed from inside and around the product.
General Condition
Check that no damage has occurred during
delivery and siting.
Electrical Door
Interlock Check that the retort door cannot be opened when
there is no power to the furnace.
Panels
Check that all covers and access panels are
securely fitted.
General Access
Check that there is sufficient clearance around the
top and all sides of the product (refer to section
7.3).
Ventilation
Check that the product has been installed in a well
ventilated area.
Extraction
If a room extraction system is in operation (not
supplied by Carbolite Gero), check that there is
sufficient clearance between the extraction hood
and the product.
Gas Supply
Check that the gas supplies (not supplied by
Carbolite Gero) are correct and appropriate for the
equipment.
Electrical Supply
l
Check that the voltage stated on the product
rating label matches the electrical supply of the
installation site.
l
Check that all electrical supply cables are
securely attached to/ plugged into the product.
Cooling Water
Supply
l
Check that the connections between the water
supply and furnace are secure.
l
Check that the connections between the retort
and the furnace are secure.
34