40
docs.carbide3d.com
41
6.
Use the 2mm hex key and one (1) M3x4mm
flat head screw to secure the tail of the Y-Axis
drag chain to the single PEM nut in the tail
bracket. Use the center through-hole furthest
from the end of the drag chain as shown in
Figure 6‑14
.
Install the X‑Axis Drag Chain
1.
Reach over the X-rail and lift the X-Axis drag
chain. Lay it flat along the length of the X-rail
with the head curling upwards near the
Y2-carriage.
2. Curl the head of the drag chain up and
towards the Z-Plus and rest it on top of
the X-Axis drag chain head bracket. See
Figure 6‑15
.
3.
Use the 2mm hex key and two (2) M3x4mm
flat head screws to secure the X-Axis drag
chain to the head bracket. See
Figure 6‑15
.
4.
Use the 2mm hex key and one (1) M3x4mm
flat head screw to secure the tail of the X-Axis
drag chain to the single PEM nut in the tail
bracket. Use the center through-hole closest to
the end of the drag chain. See
Figure 6‑16
.
3.
Reach over the X-rail and lift the tail of the
Y-Axis drag chain with your left hand and the
head with your right, as shown in
Figure 6‑11
.
4.
Rest the tail flat on the tail bracket, and the
head on the Y-Axis drag chain head bracket
on the
OUTSIDE
of the Y1-carriage. See
Figure 6‑12
.
5.
Use the 2mm hex key and two (2) M3x4mm
flat head screws to secure the Y-Axis drag
chain to the head bracket as shown in
Figure 6‑13
.
Figure 6-11
Figure 6-12
Figure 6-13
Figure 6-14
Figure 6-15
Figure 6-16
Содержание Shapeoko XL
Страница 1: ......
