CARBATEC.C OM.AU
WDS-4080P
MAINTENANCE & TROUBLESHOOTING
TROUBLESHOOTING
TO PREVENT INJURY TO YOURSELF or damage to the wide drum sander, turn the
switch to the “OFF” position and unplug the power cord from the electrical receptacle
before making any adjustments.
PROBLEM
LIKELY CAUSE(S)
SOLUTION(S)
The machine does
not work when
switched on.
1. No power supply.
2. Defective switch.
1. Check all plug connections. Check the
cable for breakage. Check the fuse, or
reset circuit breaker.
2. Return machine to your local dealer for
repair.
Sanding drum does
not come up to
speed.
1. Extension cord too light or
too long.
2. Low current.
1. Replace with adequate size and length
cord.
2. Contact a qualified electrician.
Machine vibrates
excessively.
1. Stand or base on uneven
surface.
2. Bearings worn.
1. Adjust stand or base so that it rests
evenly on the floor.
2. Replace bearings.
Sanded edge not
square.
1. Table not square to sanding
drum.
1. Follow table alignment procedure
(page 20).
Sanding marks on
timber.
1. Wrong grit sanding sleeve.
2. Feed pressure too great.
1. Use coarser grit for stock removal and
fine grit for finish sanding.
2. Do not force workpiece against drum.
27
