FOR TECHNICAL SUPPORT CALL
1800 658 111
WDS-4080P
Fig. H3
Fig. H4
NOTE: In some cases, if the abrasive strip stretched, it may be necessary to
re-adjust or reposition the abrasive clip points on the abrasive strip. Ensure
the tension remains positive on the abrasive strip during extended use.
3.
Once the abrasive strip is secured
in the left clip, stand in front of the
unit and radially wrap the abrasive
material. Roll the drum away from
you with your left hand while holding
tension on the abrasive strip with
your right hand and guiding the
material onto the drum. Use this
technique to wrap the abrasive
strip edge to edge radially around
the drum. Make sure you do not
overlap the material as you wrap
the abrasive. The material should
be flush to slightly gapped, but not
overlapped.
Fig. H3
4.
When you have completely wrapped
the drum, keep tension on the strip
and insert the remaining tapered
end of the strip into the slot in the
drum. Using your right hand, raise
the tensioner clip completely to
open the jaws. Insert the tapered
end of the abrasive strip, and
release the tensioner clip to secure
the abrasive strip. The tensioner clip
will secure and tension the abrasive
strip during use and will hold tension
in the event the strip stretches
during use. If the abrasive strip is not
tightly captured, the tensioner clip
was not raised sufficiently to open
the jaws properly before inserting
the abrasive strip.
Fig. H4
ASSEMBLY
18
