Carbatec TS-C250P, Руководство пользователя

Страница: 22 / 36

Please Save This Manual For Future Reference - 21 -
TROUBLE SHOUTING GUIDE
PROBLEM PROBABLE CAUSE SOLUTION
Saw Will Not Start
Saw not plugged in. Plug in saw.
Fuse blown or circuit breaker tripped. Replace fuse or reset circuit breaker.
Cord damaged. Have cord replaced by a certified electrician.
Overload Kicks Out
Frequently
Extension cord too light or too long. Replace with adequate size cord
Feeding stock too fast. Feed stock more slowly.
Blade in poor condition (dull, warped,
gummed).
Clean or replace blade.
Blade binding due to misaligned rip fence.
Check and adjust the rip fence. See rip fence
instructions.
Blade binding due to warped wood. Select another piece of wood.
Low house current. Contact your electrical company.
Does Not Make Accurate
45 And 90 Rip Cuts
Positive stop(s) not adjusted properly.
Check blade with square and adjust positive
stop.
Tilt angle pointer not set properly.
Check blade with square and adjust pointer to
zero.
Material Pinches Blade
When Ripping
Rip fence not aligned with blade. Check and adjust rip fence.
Warped wood. Select another piece of wood.
Material Binds On Splitter
Splitter not aligned correctly with blade kerf. Check and align splitter with blade kerf.
Saw Makes Unsatisfactory
Cuts
Dull blade. Replace blade.
Blade mounted backwards. Turn blade around.
Gum or pitch on blade.
Remove blade and clean with serpentine and
steel wool.
Incorrect blade for work being done. Change the blade.
Gum or pitch on table causing erratic feed. Clean the table with turpentine and steel wool.
Blade Does Not Come Up
To Speed
Extension cord too light or too long. Replace with adequate size extension cord.
Low house current. Contact your electric company.
Motor not wired for correct voltage. Refer to motor and /or nameplate.
Machine Vibrates
Excessively
Table not mounted securely to cabinet stand. Tighten all mounting hardware.
Stand is on uneven floor. Reposition on flat level surface.
Damaged saw blade. Replace blade.
Bad V-belt(s). Replace V-belt(s).
V-belts not tensioned properly. Adjust V-belt tension.
Bent pulley. Replace pulley.
Improper motor mounting. Check and adjust motor mounting.
Loose hardware. Tighten all nuts, bolts and set screws.
Blade Does Not Raise Or
Tilt Freely
Sawdust or dirt in raising or tilting
mechanisms.
Brush or blow out loose dust or dirt.