Carbatec TJ-250P, Руководство пользователя

Страница: 12 / 31

Operating Instructions (Overhand Planer or Jointer)
1. Make sure you have read and fully understood the General Instructions and safety precautions that
are printed in the preceding pages of this manual.
2. Before connecting the machine to the supply; check for obvious signs of damage, paying particular
attention to the plug and the power cable. Rectify or have rectified any damage you discover.
Check the blades are not damaged; that they are clean and sharp. Change the blades if necessary.
3. Connect up your dust extraction system to ensure best possible cutting action.
4. Set the fence, leaving sufficient exposed width of planer blades for you to machine the edge
dimension of the workpiece.
5. Check the fence is also set to the correct and desired angle for you cutting operation.
6. Check that all accessories, tools etc., which have been used to set the machine up, are removed
and set carefully aside or stowed away correctly.
7. Lower the infeed table to give the required depth of cut, (e.g. maximum depth to work badly
distorted or very roughly finished timber, minimum to ‘finish’ a fine straight cut off a saw?).
8. Ensure that the Autofeed Engage Control in the in neutral (lower lock) position.
Fig 10
Fig 11
a
b