Carbatec TJ-250P, Руководство пользователя

Страница: 14 / 31

5. Loosen the cutterhead guard mounting swing arm and swing up and completely to the left (or
completely remove if desired)
6. Loosen the Fence Securing Clamp, pull Fence Assembly towards the front of the machine and
completely remove it.
7. Loosen and slightly pull out the captive Infeed and Outfeed Table Locks on the rear of the machine.
8. One at a time, lift the Outfeed, and then the Infeed Tables up from the rear, and swing them over
toward the front of the machine.
9. Swing the Dust Extraction Hood up and over to the top position (Fig 12) ensuring the clip is
engaged with the pin.
10. Connect up your dust extraction system to ensure best possible cutting action.
11. Check that there are no foreign objects e.g. old nails, screws, small stones etc. embedded in the
material you are about to cut.
12. Measure the size of the wood you want to thickness. Set the thicknesser bed to this dimension
against the depth scale on the side of the machine.
13. Press the green start button and allow the cutter block to run up to full speed.
14. Shift the Autofeed Engage Control to the upper, ‘run’ position
15. Take workpiece and orientate the material so that the face you want cut is facing up.
16. Push the material firmly into the feed side of the machine (left side, with Autofeed Controls) until
the Autofeed roller ‘picks up’ the material and pulls it through the machine. (Fig 13)
17. Do not push or pull the material while it is being automatically fed through the machine.
18. Move around to the ‘back’ of the machine and take hold of the workpiece to prevent it falling to the
floor when the machining pass is complete.
19. Measure the dimension you have just cut and calculate how much more material you have to
remove to reach the required size. Raise the thicknessing bed for the new cut.
20. Repeat the process until you desired thickness is achieved remembering that you may need to
machine both rough sides for a finished board.
21. When your cutting process is complete, press the red stop button, and allow the machine come to
a complete stop before making any adjustments.
22. If changing back into Jointing mode, remember to change the Autofeed Engage Control back into
the lower locked ‘neutral’ position and reverse steps 5 through 9.