8
ASSEMBLE STAND
All the following stand pieces except the rubber pad should be assembled with the M8 x 1.25 x 16
mm carriage bolts, 8 mm washers, M8 hex nuts.
1. Place the face plate upside down on a
level surface. Fasten the rear plate
and front plate to face plate using
carriage bolts. Place the 4 L type set
plates on the corner of stand, install the
rubber pad, insert 4 Hex nuts and 4 flat
washers into the rubber pad and attach
the pad to the stand corners. Attach the
lower bracket to the stand sides. (Fig.5)
Fig.5
2. Attach the motor plate to the upper bracket using M8
carriage bolts x2 ,M8 Washer x2 and M8 Nut x2
(Fig.6) Please note below the holes for attachment.
Fig.6
3. Attach the motor plate with the upper
bracket to the inside of the stand as
shown in (Fig.7) using M8 carriage bolts
x2 ,M8 Washer x2 and M8 Nut x2
4. Turn over the stand on its pad to
square out the sides, tightening all
the above loose nuts.
Fig.7
