Pg.40
-42-
Model G0834 (Mfd. Since 12/17)
11.
Place straightedge in each position shown
in
Figure 60
, and adjust eccentric bushings
under infeed table so straightedge lies flat
against both tables.
12.
Repeat
Step 10
as many times as necessary
until infeed table is parallel with outfeed table.
13.
Tighten set screws on each eccentric
bushing on infeed table.
14.
Re-install front and rear table covers, table
locks, and cutterhead lock, and close
cutterhead pulley cover.
15.
Perform
Setting Outfeed Table Height
on
Page 37
.
7.
Place straightedge in each position shown
in
Figure 58
, and adjust eccentric bush-
ings under outfeed table so straightedge
touches cutterhead body while lying flat
across outfeed table.
8.
Repeat
Step 7
as many times as necessary
until outfeed table is parallel with cutterhead.
9.
Tighten set screws on each eccentric
bushing on outfeed table.
10.
Place straightedge halfway across infeed and
outfeed table, and adjust infeed table even
with outfeed table, as shown in
Figure 59
.
a ine e re ent
Straightedge
iti n
r
O erhead ie
Figure 58.
Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
Straightedge
Outfeed a e
Infeed a e
Figure 59.
Infeed and outfeed tables set evenly.
a ine e re ent
Straightedge
iti n
fr
O erhead ie
Figure 60.
Straightedge positions for checking
infeed/outfeed table parallelism.
