Pg.35
Model G0834 (Mfd. Since 12/17)
-37-
4.
Loosen hex nuts on motor tension rods
(see
Figure 43)
.
5.
Loosen motor mount fasteners (see
Figure 43)
.
6.
Position motor as needed to align motor
pulley with cutterhead pulley.
7.
Tighten motor mount fasteners. V-belts
should be parallel and aligned, as illustrated
in
Figure 42
on
Page 36
.
8.
Press down on motor until there is proper
tension on V-belts. While holding motor
down, tighten hex nuts on tension rods
(see
Figure 43)
.
9.
Check belt tension (refer to
Step 3
of
Tensioning V-Belts
on
Page 35
for
instructions).
10.
Replace rear access motor cover and close
cutterhead pulley cover.
Setting Outfeed
Table Height
Items Needed
Qty
Open-End Wrench 17mm .................................. 1
Precision Straightedge ...................................... 1
To set outfeed table height:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove cutterhead guard and fence
assembly.
3.
Loosen outfeed table lock and positive stop
bolt jam nut (see
Figure 44
).
The outfeed table height must be even with the
top of the cutterhead knives when they are posi-
tioned at top dead center. If the outfeed table is
set too low, there will be snipe. If the outfeed table
is set too high, the workpiece will hit the edge of
the outfeed table during operation, increasing the
chance of kickback.
Outfeed Table Lock
Positive Stop Bolt
Jam Nut
Figure 44
. Location of outfeed table lock,
positive stop bolt, and jam nut.
Figure 43.
Location of motor tension rods, hex
nuts, and motor mount fasteners.
Motor Mount
Fastener (1 of 4)
Tension Rods
w/Hex Nuts
