Reverse this process to fit new
blade, ensuring the blade teeth are
facing forward, and teeth are pointing
DOWN in your right hand.
4.
Apply correct blade tension, and
recheck tracking, alignment etc. as
per instructions.
5.
Refit the table infill and fence
assembly and table alignment pin.
J
. SETTING THE
CUTTING HEIGHT
The upper blade guide should always
be set as close as practical against
the work. To adjust, loosen the wing
nut at the side of the upper wheel
housing, and set the blade guide to
the required height. Tighten wing nut
after setting.
Fig. J
K.
SAW TABLE TILT
1.
For bevel cuts the saw table tilts
steplessly through 45°. To tilt, loosen
the wing nut on the table trunnions,
set table to the required angle and
tighten the wing nut again.
Fig. K
2.
It is recommended to verify the
correct angle setting by making trial
cuts in scrap wood.
CARBATEC.C OM.AU
BS-245H
OPERATION
Fig. J
Fig. K
OPERATION
25
