3
Assembly & Operation
To fit or replace the cutting wheel, first take out the removable
side of the cutting table. Remove nut and washer using the
wrench provided.
Position the blade against the black flange ensuring that the
directional arrow on the blade matches that on the cutting
table. Replace the front flange and nut. Do not over tighten!
Before replacing table top, fasten guard support in the slot
behind the blade opening using the screws provided. Attach
the blade guard to the support using bolt and wing nut.
Fill the reservoir to a point just below the overflow opening at
the top of the drain plug. Replace cutting table. Check
frequently during use – do not allow the blade to run dry.
Operating Instructions
Straight cuts
Place the Rip Guide on the preferred side of the table top and
line up with the rule edge to the required measurement of the
tile to be cut. When correctly aligned, lock in place by pushing
the adjuster firmly downwards.
Position the tile on the table top.
Switch on the machine.
Maintain an even pressure, hold the tile against the cutting
guide and push steadily through the cutting wheel. When the
cut is complete, then switch off the machine.
