Version 22.10.2021
HW:CAM(V98/99/100)/(V45/46)
CI-RL4-MBN6
P
a
g
e
6
1.4.1.
Adjustment – power supply output (dip 1)
If set to
ON
, the video interfaces’ red wire will 12V (max 3A) with engaging the
reverse gear and additionally 10 more seconds delay for the time of the front camera’s back-
switching after the reverse gear has been disengaged. Furthermore, the red wire’s power
supply for the front cam becomes active with manually front camera switching (short press
of the external keypad).
If set to
OFF
, the video interfaces’ red wire will supply per12V ACC (max 3A).
Description of the power supply output: see chapter “Power supply output”.
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs. Then the disabled inputs will
be skipped while switching through the video interfaces inputs.
Note:
Dip 4 is out of function and has to be set to
OFF
!
1.4.3.
Rear-view camera settings (dip 5)
If set to
OFF
, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to
ON
, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.4.
Activating – front camera back-switching (dip 6)
If set to
ON
, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
(Attend to correct adjustment of the power supply output (dip1)!
1.4.5.
Activating the guidelines (dip 7)
If set to
ON
, the guidelines will be shown on the display. If set to
OFF
, the guide lines won’t
be visible on the display.
Note:
If there is no communication between interface and the vehicle`s CAN-bus (several
vehicles aren’t compatible), the reverse gear guide-lines can`t be shown during the vehicle’s
operation, even if they once appear after having switched the system to powerless
1.4.6.
Monitor selection (Dip 8)
Dip 8 customizes the monitor-specific video settings.
If the monitor doesn’t give a satisfying picture, change the dip position while a working video
source is connected to the chosen input of the interface.
Disconnect the 10pin plug at the interface box between every change of the dip setting.
After each Dip-switch-change a power-reset of the interface box has to be performed!
