Version 07.10.2021
HW: CAM(100)/(V50+V41)
CI-RL4-ELiNK
P
a
g
e
8
1.4.2.
4 dip - red
By using the Dip-switches, the vehicle can be chosen which the interface
will be connected to.
For all vehicles, all 4 dip switches must be set to OFF.
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The interface is designated to be connected behind the vehicle`s monitor.