Version 26.11.2020
HW: CAM(V100)/UP(V20)
RL4-PCM50
P
a
g
e
18
2.5.3.
After-market rear-view camera
Some vehicles have a different reverse gear code on the CAN-bus which the video-interface
is not compatible with. Therefore, there are two different ways of installation. If the video
interface receives a signal of the reverse gear, the green wire
“Reverse
-
OUT”
of the 12pin
cable should carry +12V while the reverse gear is engaged.
Note:
Do not forget to set
video interface’s
dip5 to ON before testing.
2.5.3.1.
Case 1: Interface receives the reverse gear signal
If the interface de12V on the green output wire of the 12pin interface cable while
reverse gear is engaged, the video interface will automatically switch to the rear-view
camera input
“Camera IN”
while the reverse gear is engaged.
Additionally, the +12V (max. 3A) power supply for the rear-view camera can be taken from
the green wire of the 12pin interface cable.
