17.
Loud pump noise/no water
from brew head.
Water tank drips/leaks
when removed.
The appliance does not
operate
(no power).
No steam produced from
the frothing wand.
No water in water tank.
Air blockage in pump.
Water tank is not in the
correct position.
The base valve on the bottom
of the water tank may be
stuck.
Not plugged in/power outlet
damaged.
Mechanical or electronic
defect.
The Coffee/Steam button is
not set for the correct
function.
The white Steam indicator is
not illuminated.
Frothing wand blocked by
milk or calcium deposits.
Fill water tank with fresh,
cold water.
Coffee/Steam button should
be illuminated white for
steam/froth function. Place
small frothing pitcher under
frothing wand and turn
Selector Dial to steam. After
a few seconds a steady
stream of water should
emerge from the frothing
wand. Allow a few ounces
of water to flow out of the
frothing wand then turn the
Selector Dial back to the
center position "•".
Adjust the water tank so it is
in the right position. See
chapter 3, a.
Use finger to push valve
back into place while holding
the water tank over a sink.
Plug the power cord into
a functioning wall outlet
correctly, if the appliance
still does not work, please
contact Capresso Customer
Service.
Contact Capresso Customer
Service.
Ensure the Coffee/Steam
button is set for Steam. The
indicator light should be
solid white.
Only after the Coffee/Steam
button is pushed and illumi-
nated in solid white will the
machine be ready to steam.
Turn the Selector Dial to the
center "•" position. Carefully
use a needle to loosen the
milk residue. Then steam
again. See chapter 10,k to
clean the frothing tip. See
chapter 11 for decalcifying
the frothing wand.
Symptom Cause Corrections
