NOTE:
Do not operate the machine’s frothing wand without the frothing tip
and o-ring in place.
11. Decalcifying
When making espresso, always use cold, clean water. Using spring water or
filtered water will slow down calcium build up. We recommend decalcifying the
machine after 100-200 uses or at least every 2-3 months.
• When using commercial decalcifying agents it is important to follow their
instructions. You can also use Capresso Cleaning Solution, available at
www.capresso.com. Dissolve 1 packet of Capresso Cleaning Solution with
30 oz. of water and add to the water tank.
NOTE:
Do not use vinegar as this will considerably shorten the life of the seal
inside the brew head.
Decalcifying the Brew Head
a) Remove the portafilter.
b) For best results unscrew the screen inside the brew head. Wipe off any
coffee residue with a damp cloth.
c) Fill the water tank with the decalcifying solution and water.
d) Place a large bowl beneath the brew head.
e) Push the ON/OFF button and turn the Selector Dial to the left, cup " "
position. Allow 1/3 to 1/2 of the solution to be pumped through the system
and the brew head.
NOTE:
There is no need to wait for the blue ready light to illuminate.
f) Turn the Selector Dial to the center "•" position to stop the process.
g) Let the machine sit for approximately 10 minutes.
Decalcifying the Frothing Wand
h) Fill a pitcher with 6 to 8 oz. of cold water and immerse the frothing wand
into the cold water.
i)
Ensure the Coffee/Steam button is illuminated in white for steaming/frothing
function. Turn the Selector Dial to the right, steam/frothing " " position and
let steam pass through for about 30 seconds. Repeat this process three or
four times.
j)
Now process the remaining decalcifying solution through the brew head by
pressing the Coffee/Steam button until illuminated blue and turn the
Selector Dial to the left, cup symbol " " until all decalcifying solution
has been emptied from the water tank.
Rinsing the System
k) Remove the water tank and rinse thoroughly, then fill with fresh cold water.
l)
Repeat above steps (d through j ) with fresh cold water.
m) Replace screen in the brew head and tighten the screw securely.
14.
