Caple WC6218, Техническая информация

Страница: 19 / 29

13/23
2 ） .
After removing the inner air-duct board, we can see suction pipe and capillary pipe joint
（ Fig.7 ）
A: Capillary solder joint. B: Suction pipe solder joint C: Upper compartment fan connector
D: Upper compartment sensor connector E: Heater fan connector F: Heater connector
G: Defrost sensor connector H: Air cycling fan connector
Ｉ
: Lower compartment sensor
J: evaporator
6.1.3 ． How to remove the evaporator
The process: Remove the shelves → Remove the control panel film → Remove the screws
→ Remove the display supporter → Remove the middle electrical box → Remove the
screws → Remove the upper and lower air-duct board. → Remove the inner air-duct board
→ separate the evaporator from the compressor and dry filter on the joints.
You can see the evaporator is joint to suction pipe and capillary.
（ Fig.7 ） Heat the joint E,G
（ Fig.17 ） in the compressor room, and disconnect the pipe from compressor by using
the plier. Then remove the evaporator and capillary and suction pipe upward.
6.1.4. How to remove the display PCB
The process: remove the display supporter
→ remove the display PCB
After removing the display supporter, from the back of the supporter pull the hooks, and remove
Fig.7
C
D
E
F
G
H
I
J
B
A