Caple Vela VEL410BK, Инструкция по эксплуатации

Страница: 13 / 24

13
Please keep this instruction manual for future reference
Instruction manual VEL410BK/CO/GD
I N S T A L L A T I O N
5

         
         





            




2
1 Installation (Vent outside):
Attention! Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
1. Drill 3 holes to accommodate the bracket. Screw and tighten the bracket onto the
wall with the screws & wall plugs provided.
2. Lift up the cooker hood and hang onto the wall bracket hook .
Place the fixing bracket on the ceiling and mark the position of the holes. The fixing plate
should be securely fixed to the ceiling.
1) 4 x ST6 (40mm) screws for wooden ceilings.
2) 4 x M6 (60mm) expansion bolts for cement ceilings.
› Pass the fixing wires and the power cable through the fixing bracket cover.
NOTE:
The next stage of the installation process MUST be completed by two people.
› Fix the 4 steel wires to the fixing bracket using the wire lockers.
› Connect the power cable.
› Adjust the steel wires to a suitable length and check they are equal. This will ensure the
hood is perfectly parallel to the ceiling and the correct position for use.
Wire locker
Steel wire
NOTE:
The next stage of the installation process MUST be completed by two people.
› Fix the 4 steel wires to the fixing bracket using the wire lockers.
› Connect the power cable.
› Adjust the steel wires to a suitable length and check they are equal. This will ensure the
hood is perfectly parallel to the ceiling and the correct position for use.
3
3.
Secure the body with security screws,
Use 2 pcs of wall plug and
2pcs of
ST4*
30
mm screws
to fix the hood
4. Place the plastic duct on the cooker hood.
3
3.
Secure the body with security screws,
Use 2 pcs of wall plug and
2pcs of
ST4*
30
mm
4. Place the plastic duct on the cooker hood.
› Push the fixing bracket cover up to the
fixing bracket.
Magnets will fix it in place.
NOTE:
The next stage of the installation process MUST be completed by two people.
› Fix the 4 steel wires to the fixing bracket using
the wire lockers.
› Connect the power cable.
› Adjust the steel wires to a suitable length and
check they are equal. This will ensure the hood is
perfectly parallel to the ceiling and the correct
position for use.
Wire locker
Steel wire
› Pass the fixing wires and the power cable through the fixing bracket cover.
WARNING:
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
› Push the fixing bracket cover
up to the fixing bracket.
Magnets will fix it in place.
WARNING:
Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.