Caple Vela VEL410BK, Инструкция по эксплуатации

Страница: 12 / 24

12
Please keep this instruction manual for future reference
Instruction manual VEL410BK/CO/GD
I N S TA L L AT I O N
Place the fixing bracket on the ceiling and mark the position of the holes. The fixing plate
should be securely fixed to the ceiling.
1. 4 x ST6 (40mm) screws for wooden ceilings.
2. 4 x M6 (60mm) expansion bolts for cement ceilings.
› Pass the power cable through the carbon filter support. Gently lower the filter support
until it rests on the hood.
› Slide the charcoal filter onto the power cable and lower it down so that it rests on top of
the support.
› Pass the power cable through the metal top cover. Place it on top of the charcoal filter.
I N S T A L L A T I O N
5

         
         





            




2
1 Installation (Vent outside):
Attention! Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
1. Drill 3 holes to accommodate the bracket. Screw and tighten the bracket onto the
wall with the screws & wall plugs provided.
2. Lift up the cooker hood and hang onto the wall bracket hook .
Place the fixing bracket on the ceiling and mark the position of the holes. The fixing plate
should be securely fixed to the ceiling.
1) 4 x ST6 (40mm) screws for wooden ceilings.
2) 4 x M6 (60mm) expansion bolts for cement ceilings.
› Pass the fixing wires and the power cable through the fixing bracket cover.
NOTE:
The next stage of the installation process MUST be completed by two people.
› Fix the 4 steel wires to the fixing bracket using the wire lockers.
› Connect the power cable.
› Adjust the steel wires to a suitable length and check they are equal. This will ensure the
hood is perfectly parallel to the ceiling and the correct position for use.
1
2
I N S T A L L A T I O N
5


 

 




         





            




2
1 Installation (Vent outside):
Attention! Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
1. Drill 3 holes to accommodate the bracket. Screw and tighten the bracket onto the
wall with the screws & wall plugs provided.
2. Lift up the cooker hood and hang onto the wall bracket hook .
Place the fixing bracket on the ceiling and mark the position of the holes. The fixing plate
should be securely fixed to the ceiling.
1) 4 x ST6 (40mm) screws for wooden ceilings.
2) 4 x M6 (60mm) expansion bolts for cement ceilings.
› Pass the power cable through the carbon filter support. Gently lower the filter support
until it rests on the hood.
› Slide the charcoal filter onto the power cable and lower it down so that it rests on top
of the support.
› Pass the power cable through the metal top cover. Place it on top of the charcoal filter.
› Pass the fixing wires and the power cable through the fixing bracket cover.