Caple BOG622E00X, Установка - Использование - Обслуживание

Страница: 7 / 22

ADJUSTMENTS OF THE MINIMUM SETTING FOLLOWING
CONVERSION TO A DIFFERENT GAS TYPE
Proceed to disassemble the front panel:
- for the front panel, unscrew the two rear fixing screws
- for glass fronts, unscrew the two lock rings under the knob.
Conversion from natural gas to liquid gas
After removing the front panel, insert the screwdriver in the hole in the front wall of the instrument
panel and turn regulation screw A clockwise.
Conversion from liquid gas to natural gas
After removing the front panel, light the over with
thermostat set to 250°C for at least 10-15
minutes. Then, turn the thermostat to the minimum position. Then turn the bypass screw
A counterclockwise until you see a reduced by stable flame.
Check that the flame does not go out when the door of the oven is opened and closed repeatedly.
If the flame goes out, slight increase the minimum regulation setting.
After converting the appliance to a different type of gas, remember to change the data plate to one
with the new data (gas type and pressure).
REPLACING THE GAS GRILL NOZZLE
1) Remove the burner screw located at the top front of oven cavity.
2) Remove the burner together with its heat elements.
3) Remove the nozzle using the 7 mm socket wrench
4) Fully tighten the new nozzle which must be of the diameter indicated in the table.
5) Put back the burner and secure it with the screw.