4.3
Removing the Control Tap from the fire.
4.3.1
Remove the burner assembly as in section 4.1.
4.3.2
Pull the control knob off the control tap spindle.
4.3.3
Loosen and remove the two gas pipe retaining nuts from the control
tap and release the ends of the gas pipes from the control tap body.
Remove the push in thermocouple from the end of the control tap.
4.3.4
Unscrew the control tap locknut from the front of the control panel and
remove the control tap.
4.3.5
To refit a control tap, reassemble in reverse order noting that the control
tap locates with a flat in the control panel. Carry out a gas tightness
test after re-assembly.
4.4
Removing the Thermocouple
4.4.1
Remove the burner assembly as in section 4.1
4.4.2
Remove the push in thermocouple from the end of the control tap and
and remove the thermocouple retaining nut from the mounting bracket
on the burner assembly.
4.4.3
Re-assemble in reverse order and carry out a gas tightness test.
4.8.3
Replace in reverse order and check correct operation of the appliance.
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
GAS SAFE registered gas installer. The part numbers of the replaceable parts are
as follows, these are available from Gallery Fires who may be contacted at the
address shown overpage.
Coal / Ceramic Pack
B-67400
Decorative Coals
B-141060
L/H Fibre Board (Plain)
B-67550
R/H Fibre Board (Plain)
B-67560
Lower Fibre Board (Plain)
B-67540
Upp. Rear Fibre Board (Plain)
B-67530
Gas Valve
B-67090
Burner Engine
B-67890
Ignition Wire
B-67910
27
