19
HIT THE LIGHTS!
Each model in the Precision Series line features night-lights. There are located on the rotisserie panel and
point downward to illuminate the entire grilling surface. Each light is rated at 20W and is operated by a switch
located on the front panel. Say goodbye to clunky night-lights and cumbersome extension cords. Now you
can grill all night till the break of dawn and beyond.
Go on, “Hit the Lights!”
REPLACEMENT OF REGULATOR AND HOSE:
The pressure regulator and hose assembly supplied with the unit must be used. For Natural Gas installations
the Regulator will be supplied with your BBQ and must be used. If replacement is required it must be replaced
with an AS/NZS certified NG regulator.
Your ULPG BBQ is supplied with a regulator and hose already fitted and must be used. If replacement is
required, it must be replaced with an AS/NZS certified LPG hose and regulator.
These parts can be Obtained by Calling Arisit Parts on 1300 762 219.
Do not use the grill if the odor of gas is present. If the unit is LPG, screw the regulator into the tank and leak
check the hose and regulator connections with a soap and water solution before operating the grill. Turn all
knobs to OFF then turn on the gas supply. If ULPG, is there gas in the tank? Always keep your face and body
as far away as possible from the grill when lighting.
IMPORTANT: Using the Grill
Grilling requires high heat for searing and proper browning. Most foods are cooked at the MEDIUM heat setting
for the entire cooking time. However, when grilling large pieces of meat or poultry, it may be necessary to turn
the heat to a lower setting after the initial browning. This cooks the food through without burning the outside.
Foods cooked for a long time or basted with a sugary marinade may need a lower setting near the end of the
cooking time.
•
Check to be certain the drip pan and grease tray are in place.
•
Light the grill burners using the instructions provided in this Use and Care Guide. Lighting Instructions are
found on the inside of the drip pan tray sleeve.
•
With the grill lid open, turn the control knob to HIGH to light. Preheat the grill for 5 to 10 minutes.
•
Place the food on the grill racks and cook to the desired doneness. Adjust heat setting, if necessary.
The control knob maybe set to any position between HIGH and LOW. Note that most barbecuing is
performed using a medium to low flame. Adjust the flame to suit your food requirements.
•
Allow the grill to cool and clean the grates, drip pan and grease tray after each use.
Note: If using ULPG gas, your preheat time may be shorter than recommended. To prevent
overcooking or burning, you may want to lower heat settings.
•
DO NOT leave the grill unattended while cooking.
•
KEEP a spray bottle of soapy water near the gas supply valve
and check the connections before each use.
•
DO NOT attempt to light the grill if odor of gas is detected.
•
WAIT five minutes before relighting a hot grill.
USING THE GRILL / FEATURES
Содержание ACG40RBI.1L
Страница 29: ...29 WIRING SCHEMATICS...
Страница 33: ...33...
