TUTA-GW2 user manual
（
Version:V1.4)
9
Color
Action
Status
Light two seconds
Successfully reset factory setting.
Note: 1.Slow flashes 1 time per second, quick flashes 2 times per second.
2. Under normal working conditions, the indicator can be closed absolutely: Under normal
working conditions, press SET key for 5-10 seconds, the indicator will open/close. A
“
DI
”
tone
can be heard after setting successfully.
3. If you press SET key for more than 10 seconds, the camera will be reset.
Chapter 2 Installation
2.1 Install the SIM/USIM card
•
Remove the rubber cover from the left side of the camera.
•
Open the SIM/USIM card slot by pressing the small dot beside the card slot with
the tip of a pencil, and pop open the slot.
•
Insert the card into the slot.
•
Push the slot back into place.
•
Put the rubber cover back in its place.
2.2 Extending the camera
’
s base board
•
Hold the base of the camera and pull the top part and the bottom part (base) in
opposite directions (i.e. away from each other).
•
Then the slot buckle will be pulling open.
•
The head of the camera can now be moved freely and located at any direction.
2.3 Connecting to power adapter
•
Connect the adapter to an AC power, and connect the mini-USB plug to the
power interface of the camera .(See Figure 1)
•
The camera has a built-in rechargeable Lithium battery.
•
The camera will notify the user when the power changes. For example, if the
power adapter is disconnected or failure of the AC power occurs, the camera
will notify the user
“
External power cut. The device is operating on battery.
”
•
If the camera is again connected to the external power, or the AC power is
available again, the notification will be sent to the user, i.e.
”
The device is now
