Cap Strength FM-H1007A125, Руководство пользователя

Страница: 10 / 17

10
Step 5:
Starting with the 15lb weight stack (78) then the 10lb weight
stack (77), place the weight stacks onto the guide rods (11&12).
Once done, connect the selector shaft (12) to the top plate (76)
with the plastic cap (72) top plate pin (70) and washer (68).
Then slide the entire piece onto the guide rods (11&12).
Finally, use the P pull pin (73) to secure the shaft into the
weight stack.
Step 6:
Insert the leg extension (8) into the arms coming off of
the base frame assembly (3). Fasten using bolt (32),
washers (47), and locknuts (43).
Step 7:
Vertically place the bottom main frame support (1)
onto the base frame (3). Secure it using bolts (34),
washers (47), enforcement (25) and locknuts (43).
Insert the top main frame support (2) into the bottom
main frame support (1) and secure using bolts (34),
washers (47), enforcements (25) and locknuts (43).
Step 8:
Attach the pulley immobility tube (18) to the upper main
frame support (2) with bolt (33), washers (47) and locknut
(43). Attach pulley brackets C (28) to either side of pulley
immobility tube (18) with bolts (35), washers (47) and
locknuts (43). (Note: Do not over tighten, allow pulley
brackets to move freely)