ENG 2
Step 2 To fit the batteries
1. Open the locking latch and slide off the battery compartment cover.
2. Insert the rechargeable battery pack as shown.
＊
Make sure the ‘UP’ arrow is showing, and pointing towards the top of the
handset.
3. Replace the cover and close the latch.
Step 3 To replace the belt clip
Slide the belt clip down into the slot until it clicks into place.
＊
IMPORTANT
Read these safety warnings before you charge the batteries.
1. When placing the handset in the charger, use only the rechargeable battery
pack supplied with the walkie-talkie.
2. Don’t try to fit or recharge non-rechargeable batteries.
3. Make sure the battery compartment cover is securely locked in place
when you’re charging the batteries.
4. Dispose of used batteries safely and in a way that will not harm the
environment
－
never try to burn them or put them anywhere they could get
burnt or punctured.
5. When you’re not going to use your walkie-talkie for a few weeks, take the
battery pack out so it doesn’t leak corrosive substances.
6. When the battery charge level gets low, an alert tone will be heard and the RED
LED indicator will flash once every 15 seconds. When this happens, recharge the
batteries.
7. Don’t leave dead batteries in your handset
－
they might leak if you do.
2.1 Charging the batteries
If you prefer to wall
mount the charger, use the template supplied.
Step 1
Connect the mains power lead to the charger.
Step 2
Plug the mains adapter into a 230 V AC, 50 Hz mains socket, with the
switch on the socket set to OFF.
Step 3
Then switch on at the mains socket.
＊
The walkie-talkie must be used with the mains adapter supplied.
Step 4
Place the handsets in the charging cradle
s.
Lift the belt clip off
Insert your
fingernail
behind the tab
Latch
