94
English
Sub Stereo [SSM]
If you have connected a subwoofer to the Amp 5.1, this subwoofer will play all (bass)signals that are lower than the set crossover frequency in
the menu item Crossover [XOV], independently of the selected playmode (Stereo, Movie, Music, etc.). For a pure stereo experience it is pos-
sible to route the full music signal (including the bass part) to the front speakers (FL, FR) in the playmode Stereo. This function is only available
if a subwoofer (Smart or Analog) has been selected in the menu Speakerconfiguration [SPC]. The function is set to On [ON] as factory setting,
so that the subwoofer plays the bass signals.
To play the bass signal in Stereo mode through the front speakers please do as follows:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK button.
3
Use the
" "
or " " button to select the menu item Sub Stereo [SSM] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to select the desired function:
On [ON] means that the subwoofer plays the bass signals (factory setting).
Off [OFF] means that the bass signals are played through the front speakers Front Left and Front Right.
5
Confirm and exit the menu item by pressing the "M" button.
Room Height [RHE]
To get an optimal spatial impression (3D sound) during the playback of Dolby Atmos® bitstreams, the setting of the room height is necessary.
The room height can be set up to 9.90m in 0.1m steps, with 2.5m being the factory setting.
To set the room height please do the following:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK button.
3
Use the
" "
or " " button to select the menu item Room Height [RHE] and confirm with the "OK" button.
4
Use the "+" resp. the "–" key to set the desired height.
5
Confirm and exit the menu item by pressing the "M" button.
Device Heights [DHE]
In case of using Dolby Atmos® enabled speakers that direct the sound upwards to the ceiling it is necessary to set the heights of these
speakers (for example when placed on top of normal speakers or on a nearby surface) to achive an optimal spatial surround impression (3D
sound). The heights can be set in 0.1m steps for the front and rear "Upfire" speakers seperately, with 1m being the factory setting.
