Canton DIGITAL MOVIE DM 90, Руководство пользователя

Страница: 63 / 68

63
Deutsch
English
No Virtual Surround effect
One satellite seems louder than the
other or the bearing is off-center
System does not recognize Dolby
Digital or. DTS (only „analog“ or
„pcm“ is displayed)
Volume cannot be turned up above a
certain level (max = 99)
System is quieter after switching on
than before switching on
Signal missing sometimes in surround
mode (especially voices)
No sound at center in 5.1 mode
Radio reception distorted (poor
reception, lots of noise)
1. Play mode set to stereo
2. You are not at the mid-point of the 2 satellites
and/or the distance settings do not match up with
the actual distances
1. Volume settings of the satellites are different or
you are sitting closer to one of them
1. Source has an analog connection
2. Formats not supported by source or wrong
settings selected
1. Volume limiter set to a value less than 99
1. Start-up volume set to a lower switch-on value
(standard = 50)
1. System is in 5.1 mode and no central speaker is
connected
1. System is in 2.1 mode
2. System is in Stereo mode
1. Bad antenna position
2. Station set wrongly
1. Set play mode to surround
2. Rectify the distance to the two satellites and
sub (p. 50)
1. Adjust volume using „test tone“(p. 50)
1. Connect the source with a digital output to
the DVD or Sat inputs
2. You will find more information on this in the
source device instructions
1. Set the volume limiter to the desired value,
(p. 61)
1. Set the start-up volume to the desired value
(max. = 99) (p. 61)
1. Set system back to 2.1 mode (p. 49)
1. Set 5.1 mode under „system“ (p. 49)
2. Select the play mode „surround“ (p. 49)
1. Change antenna position (stretch it open),
use a roof aerial or broadband cable network
or switch to mono reception
2. Adjust the station frequency manually (p. 55)