CanTech
14
5.3 Config. – measurement setup
Sets the AD converters and their calibration, setings thermometers, power consumption and alarm
inputs. AD converters can be used only for the first eight values (default is fitted only measuring
voltage converter).
Type - 1xAD – simple AD converter
2xAD 1. – double converter 1. input
2xAD 2. - double converter 2. input
1xT - RE3 – one thermometer on port RE3 (no need to enter the seriál number)
1xT - RC2 – one thermometer on port RC2 (at this version is not used)
nxT - RE3 – multiple thermometers on port RE3 (must enter the seriál number)
Energy – calculates the energy
Pulse – work with a delay between pulses on the inputs 1,2
Nothing – value is not used
Measure – if the value should be measured
Value – display of the measurement result after the tap of a button Measure
Serial number – number of thermometer – right mouse button to load number (at this point must
be connected just one thermometer)
Address – I2C converter address
MUX – port of I2C multiplexer
Config – configuration constant of AD converter
Number – number of measurements for averaging values
Direction – indicates, that the measured variable takes only positive values – to the measurement
around zero does not appear –0,0
Offset – displacement of converter in zero (in LSB)
Constant – conversion constant of value
Idx – index of energy or pulse (0,1)
1.hrs – if the type Energy
0..7 – 1. value of multiple
8 – energy is calculated based on arrival pulse on input
- if the type Pulse
